Melanotan 2 dosing protocol

ill be starting my MT2 protocol soon based on the feedback in this thread.

really appreciate everyone that replied and gave insight, looking forward to getting a nice tan!

think ill start with 200mcg like 3x a week before tanning, then just maintain on like 200-400mcg a week once I get my desired color

starting at 200mcg should be low enough were I can hopefully avoid sides, then ill just adjust the frequency as needed.
 
The protocol I followed was pinning MWF right before tanning. First week was 0.2 mg, second week on was 0.4mg until I hit my target tan. From that point on I'd only pin/tan if my tan had faded. Maintenance for me was 0.2mg maybe once every couple of months.

My skin is very fair, and I have always been more of a burn and peel rather than tan. My current girlfriend is similar, and I am helping her with the same protocol. She had noticeable color after 3 pin/tan sessions, and our plan is to up her dose this week. We shall find out how well she can hold the tan once she hits her target.

We are using it primarily for the tanning benefit. The only noticeable side effect thus far is the slight flushing after pinning which dissipates quickly.m

How much bac water did you use? If I don’t go tanning will it still darken my skin or is it necessary to tan? If so, how long? I’m fair skin as well
Thanks for the advice
 
How much bac water did you use? If I don’t go tanning will it still darken my skin or is it necessary to tan? If so, how long? I’m fair skin as well
Thanks for the advice
My MT2 came as 2mg/vial and I added 1ml bac so that every 0.1ml (10 units on slin pin) has 0.2mg of MT2. I could have just as easily reconstituted with 0.5ml bac and then dosed using 0.05ml or 5 units on the slin pin. It's all about working with fractions.

If you are dosing MT2 for the tanning effects, I am a believer in tanning within 30 minutes of pinning my dose, and I will not pin unless I am planning on tanning. I've not used MT2 without using a tanning bed, so I can't offer any anecdotal information on the matter.

My understanding of how we tan is that the MT2 instructs our body's melanocytes to produce more melanin, but it is the areas exposed to intense UV radiation that produce the most. We all have some areas of our body that are darker than others normally, and I suspect that without the UV radiation to inform the body where the melanin is most needed, those normally darker areas may get darker while the other areas see minimal/negligible change. Speculation on my part, so take that for what it's worth.

I can't really comment on dosing MT2 for other purposes as I have no relevant experience.
 
My MT2 came as 2mg/vial and I added 1ml bac so that every 0.1ml (10 units on slin pin) has 0.2mg of MT2. I could have just as easily reconstituted with 0.5ml bac and then dosed using 0.05ml or 5 units on the slin pin. It's all about working with fractions.

If you are dosing MT2 for the tanning effects, I am a believer in tanning within 30 minutes of pinning my dose, and I will not pin unless I am planning on tanning. I've not used MT2 without using a tanning bed, so I can't offer any anecdotal information on the matter.

My understanding of how we tan is that the MT2 instructs our body's melanocytes to produce more melanin, but it is the areas exposed to intense UV radiation that produce the most. We all have some areas of our body that are darker than others normally, and I suspect that without the UV radiation to inform the body where the melanin is most needed, those normally darker areas may get darker while the other areas see minimal/negligible change. Speculation on my part, so take that for what it's worth.

I can't really comment on dosing MT2 for other purposes as I have no relevant experience.

This is perfect. Exactly what I needed. I really appreciate it.
 
ill be starting my MT2 protocol soon based on the feedback in this thread.

really appreciate everyone that replied and gave insight, looking forward to getting a nice tan!

think ill start with 200mcg like 3x a week before tanning, then just maintain on like 200-400mcg a week once I get my desired color

starting at 200mcg should be low enough were I can hopefully avoid sides, then ill just adjust the frequency as needed.

I would dosage every day to avoid the sides. For example 100mcg every day until you are tanned enough.
 
I'm loading mt2 for the first week @250 mcg eod and taking it 1/2 hour or so before tanning bed, so far results are minimal but i do believe its working i think my conservative approach may be to nlame or i may just be a "fair skinned" "hard tanner" lol slow and steady has definitely kept dides at bay
 
Who has good melanotan right now

I've ordered a vial from pharmaqo, looks good enough

w.png

I plan to transfer it to a 10 ml vial to get 95 mcg per 0.1 ml and inject twice weekly. I'm kinda afraid of it because i hate the overtanned look but i want to see if it helps me with greying beard and hair. Wouldn't mind a light tan though
 
Currently using Qsc tested at 13mg.. I mix 2ml bac water and use only 3 lines on a slin pin once at night..

Not sure what dose this works out to be but gives me a decent colour and he'll nausea..
 
The one i started months ago is from QSC too but i haven't see any testing. Assuming it's 10mg i'm taking 300-400mcg now once a week for preservation and the only sides i ever encountered (even in the beggining) is mostly dilated capillaries on chest arms and face, my pores are getting red and i feel that flushing..all in all for 20 minutes. Thankfully no nausea or hypo feelings.
 
Top