Primo E will not dissolve no matter what

I was lazy on the displacement factor on this one, I get detailed on my true TRT/Blast blends. I made the assumption of 0.9 for the displacement. I started with only 10ml as a test run.

PWO blend

10ml total / 15%BB / 1%BA

EO as carrier

50mg/ml TNE - 500mg
50mg/ml Win - 500mg
10mg/ml Prov - 100mg

1.1g total Material

1ml = Material Displacement

1.5ml BB
0.1ml BA

BB + BA + Material Displacement = 2.6ml

Need 7.4 ml EO



P.S- heat was much more vital to this brew than anything I’ve done before. I can brew some/most regular compounds with little to no heat at all. This bitch had to get HOT.
I've noticed with Winny you need extreme heat as well, I think I did a successful brew but had to use an oven set to 425°F. What was you method for heating? Did you add the EO/bb/ba at once and then heat? Or just EO and then once cooked add the bb/ba?

I'm just wondering if such high heat can ruin the compound? Would love to hear your though on that. As I'm not sure if compounds can degrade due to hear or not.
 
As the transaction was over a year ago. Any accountability would be hard to determine at this point. Unless the seller wanted to be real nice about it.
 
Back
Top