Required depth for ventroglute injection.

[Ghandi]

Hi folks,
I was reading another thread today where depth of injection in the ventroglute was touched upon. However, I didnt want to be thought of as hijacking that thread, so I started a new one to clarify something.
Speaking of injection depth, Dennis said "If you used a 1.5" needle you just nicked or passed through the vein..the juice should be deep in muscle tissues".
So I have been injecting 200 mg of test p EOD in the ventroglute, using a slinpin for the purpose of accurate measurement. Of course this means that the needle goes in about half inch maximum. Is this far enough? If not, I will have to transfer the juice to a bigger barrel, and use one of my 23g picks.
Thanks for sharing your knowledge.
Ghandi

 

[dennis]

1/2" can work if you are injecting directly into the muscle...not through body fat then the muscle.Example..1/2" would work into delt or bi's..probably not the best choice for glutes bro..use 1" minimum there..I use 1.5"..but with longer needle you have to be carefull not to pass through the muscle..in other words..know your muscle groups and injection locations !

 

[Reinheart]

1/2" can work if you are injecting directly into the muscle...not through body fat then the muscle.Example..1/2" would work into delt or bi's..probably not the best choice for glutes bro..use 1" minimum there..I use 1.5"..but with longer needle you have to be carefull not to pass through the muscle..in other words..know your muscle groups and injection locations !

Good advice as always!

 

[Fulano]

1/2" can work if you are injecting directly into the muscle...not through body fat then the muscle.Example..1/2" would work into delt or bi's..probably not the best choice for glutes bro..use 1" minimum there..I use 1.5"..but with longer needle you have to be carefull not to pass through the muscle..in other words..know your muscle groups and injection locations !

I was going to post something, but you said it better than I would have.

 

[newkid]

1 Inch 25 Gauge all day long with glutes

 

[Ghandi]

1/2" can work if you are injecting directly into the muscle...not through body fat then the muscle.Example..1/2" would work into delt or bi's..probably not the best choice for glutes bro..use 1" minimum there..I use 1.5"..but with longer needle you have to be carefull not to pass through the muscle..in other words..know your muscle groups and injection locations !

So does this mean I have possibly shortchanged myself if I have injected juice into the fat layer?
Will it be absorbed at all, or just sit there?
Thanks for the info.

 

[dennis]

It wont just sit there but you might have been short changing yourself..

 

[Jeton]

unless ur exceptionally lean, u've probably given urself a less typical and less useful metabolization curve by injecting sub-q, as it's unlikely ur needle reached an IM depth. i agree with everything Dennis wrote here. i'd add that for most adults who aren't very slim, 1.5" is probably best for any butt shot, dorso- or ventro-gluteal.

 

[Ghandi]

I only did three test p shots using the half inch needle before I jumped on here for advice, so no big deal. Thanks again guys

 

[dennis]

Ghandi, Did you feel a boost from the first few injects ???

 

[MPM]

I tried using a 5/8' once in my glute. I was already at a pretty low bf% so I figured it would work. I was wrong lol. Shit went in smooth as melted butter but knotted up and bruised like a mofo. I personally feel a 1.25 pin works best for me.

 

[bigrobbie]

Hi folks,
I was reading another thread today where depth of injection in the ventroglute was touched upon. However, I didnt want to be thought of as hijacking that thread, so I started a new one to clarify something.
Speaking of injection depth, Dennis said "If you used a 1.5" needle you just nicked or passed through the vein..the juice should be deep in muscle tissues".
So I have been injecting 200 mg of test p EOD in the ventroglute, using a slinpin for the purpose of accurate measurement. Of course this means that the needle goes in about half inch maximum. Is this far enough? If not, I will have to transfer the juice to a bigger barrel, and use one of my 23g picks.
Thanks for sharing your knowledge.
Ghandi

Here is an internal link to a thread posted by Trainhard a while back:

https://thinksteroids.com/community/threads/134294632

Dunno if that helps or not, also...not sure if this is the same link he provides, but if it isn't here is an external link that also may help:

Ventrogluteal Injection

Sorry so late on reply...I see you have gotten good answers, but I remembered Trainhards thread and the hubpages link I had bookmarked...just wanted to toss you some additional info.

 

[Ziggajay]

It helps to have a fat ass like me. Although I have injected into the fatty tissue with the 1.5's before because I didn't go deep enough. I can't imagine using anything under 1.5.

I guess if you have a little skinny ass you should always aspirate for safety. And make sure not to hit the pelvic bone or some dumb shit.

 

[Ghandi]

Ghandi, Did you feel a boost from the first few injects ???

Yes, most definitely. It brought my intake for the week to over 1000 mg, and I pulled a couple new pb's... deadlift and back extension (weighted)