fit2beking
New Member
Me too!
MESO-Rx
Anabolic Steroids
www.performanceenhancingpharma.com
- Thread starter gotPEP
- Start date
Me too!
incrediblebulk
New Member
Just ordered for my third time. Nice cut cycle. I won't start it til March but I will have it ready. Start with test prop/tren a finish with test prop/mast.
This order was a little trickier for pep. With a bunch of pm from me but he was patient. Thanks pep.
This order was a little trickier for pep. With a bunch of pm from me but he was patient. Thanks pep.
ErikR the blood test on here where the results are 1500 is just how high a number that particular lab will post. The actual results may be 4000. The problem is not all labs will give you the total number. Theoretical you are correct if someone was using 500mg their bloodwork came back 1450 and the same person on his next cycle used 1000mg of another brand and bloodwork came back and their number came back 1450 then the second would be underdosed. But most labs cap the results at 1500. So find you a lab that will give you a larger number than 1500
Just adding 200mg of tren a week you will see good results. Especially with test and mast stack. Being a tren virgin you should start low and if you like it go up a little next time. I usually keep my tren dose at or below my test dose. I don't have to worry about hairline my head is cleaned shaven but it is dht derivative so high doses can cause balding for people predisposed.
1forthegeeks
New Member
I pinned peps test prop 125ml no pip at first now my quad is really sore
1forthegeeks
New Member
You can do the top or the side. In my opinion, the side hurts more to penetrate if your lean, but has less pip. Top goes in like butter, but you can end up with a lump from time to time.
On a prop cycle you will probably end up going where ever doesn't hurt at the moment.
Check out spot injections.
incrediblebulk
New Member
I have been pinning his sust and getting some pip but not bad. usually a day of soreness.
Did you warm the oil in hot water prior to injection? That can help. I usually rub the injection site for a couple minutes post injection.
TheHamburglar
New Member
If you're quads are virgins they're going to suck for a little bit. Just don't get intimidated by the idea of PIP cause it's gonna happen but once initiated it'll be worth it.
Quads are my #1 spot, easy to reach, can use both hands, very visible spot to make a smooth injection, and they will hold quite a bit of oil.
Quads are my #1 spot, easy to reach, can use both hands, very visible spot to make a smooth injection, and they will hold quite a bit of oil.
TaoPhD
New Member
Delts and glutes are the way to go! Wheb I pinned his Prop I got only a little PIP from hitting my delts
luckyduck
Subscriber
That is what I do also. No stiff legs for me.
Apple Ijuice2 phone
Apple Ijuice2 phone
radcon
New Member
I saw it suggested somewhere to pin in the vastus lateralis so that's what I did. It gives quite a bit of territory to hit - I personally preferred a little higher up.
I've been getting bad pip but its been my fault thinking I'm a superman 
Took me some time on this my first cycle to get it right, I think
I have been using my Quads and Gluts both getting bad pip,till I finely got smart I think
I will see tomarrow if what I did worked.
Its like from what I learned over the past few months on how to pin I Implemented in stages [
)]
First I made sure I hit the right spots to pin and not move the pin around alot,Got Pip.
Then I made sure I did not use the same pin to draw and shoot, got pip.
Then I Remembered to not forget to aspirate and Push it in nice and slow, Got pip.
Now, Now I Heat up the area to pin and take my heating pad and heat the pin with the mix, I heated it so much I thought I melted and bent the Pin
It made that thick 300mg test smooth as my wife's ass
No pip yet, We will see tomorrow when I blast legs [}
]
Good times yall/ yous guys :boobies:
Took me some time on this my first cycle to get it right, I think
I have been using my Quads and Gluts both getting bad pip,till I finely got smart I think
I will see tomarrow if what I did worked.Its like from what I learned over the past few months on how to pin I Implemented in stages [
)]First I made sure I hit the right spots to pin and not move the pin around alot,Got Pip.
Then I made sure I did not use the same pin to draw and shoot, got pip.
Then I Remembered to not forget to aspirate and Push it in nice and slow, Got pip.
Now, Now I Heat up the area to pin and take my heating pad and heat the pin with the mix, I heated it so much I thought I melted and bent the Pin
It made that thick 300mg test smooth as my wife's ass
No pip yet, We will see tomorrow when I blast legs [}
]Good times yall/ yous guys :boobies:
weekend
New Member
I gave up on aspirating.
incrediblebulk
New Member
:what:
PIP is pretty much gone this morning. I had terrible night sweats last night after only 1 pin I believe that is a good sign.
Similar threads
