I have made Masteron Propionate for the past 10+ years off and on. here is the recipe
250ml Mast Prio at 100mg/ml
25g Mast Prop
1% BA 2.5ml
20% BB 50ml
174 GSO
I recently received some raw which these days is hard to get so I was skeptical when I received and it looks like regular light fluffy powder and not Mast P.
I brewed it up normally and when I went to check on it while it was heating up I noticed it wasn't breaking down at all. 20min goes by and not budging a bit. Definitely not Mast P.
Looks like I have to send a sample off to have it tested because it definitely isn't an injectable. Have already spoken with Janoshik and paid for the test. I just have a question about that.
I'm unable to post in the Underground section but I noticed just recently someone is sending a sample to be tested. Not sure if I can post his username on here but I don't see how i can send someone a message.
250ml Mast Prio at 100mg/ml
25g Mast Prop
1% BA 2.5ml
20% BB 50ml
174 GSO
I recently received some raw which these days is hard to get so I was skeptical when I received and it looks like regular light fluffy powder and not Mast P.
I brewed it up normally and when I went to check on it while it was heating up I noticed it wasn't breaking down at all. 20min goes by and not budging a bit. Definitely not Mast P.
Looks like I have to send a sample off to have it tested because it definitely isn't an injectable. Have already spoken with Janoshik and paid for the test. I just have a question about that.
I'm unable to post in the Underground section but I noticed just recently someone is sending a sample to be tested. Not sure if I can post his username on here but I don't see how i can send someone a message.



