high-octane
New Member
Personally I've seen a lot of 200mg mast enanthate crash. The last pic you posted after 5 mins still looks like it's out of solution. Get a pot and fill with water just high enough to go over the solution when your bottle is in the pot. Stick a needle in the top of your bottle for a vent. Heat the water until it almost starts boiling then put on low. Put your bottle in the pot holding the needle top so it doesn't fall over in the water. Let it sit in the water for about a minute. Take it out and swirl it (dont shake) around for about 30 secs. Keep doing this until you put the hormone back in solution. If it crashes over night you might just be doing this every time you want to inject.
Last edited: