Powder to Liquid Oral Conversions

[master.on]

Has anyone had any experience with brewing a liquid prami solution by chance? I have been doing a lot of researching and haven't found anything on it. Thanks

Prami is a bit water soluble

20 mg/ml+ according to
Pramiracetam SML0816
61 mg/ml
pramiracetam | CAS 68497-62-1

So you can brew it at just 0.5-1 mg dissolved in water. You can add some alcohol and/or put it in the fridge so it doesn't spoil.

 

[Jbone90]

Ok awesome I'll try that out. Thanks man appreciate the help.

 

[MICHAEL SPECKMAN]

Do not use red rubber stoppers they bleed red into the finished product, and will destroy your gear,

 

[Jaxino]

Which % of PEG300 usually we need to put in? I have seen values from 80% to 20%

 

[master.on]

Which % of PEG300 usually we need to put in? I have seen values from 80% to 20%

What do you want to brew?

 

[Jaxino]

Proviron 50mg/ml
Winstrol 25mg/ml
Superdrol 10mg/ml

Already have the droppers and PEG300

 

[AliceInGains]

POWDER TO LIQUID ORAL CONVERSIONS
(Instructions below)

ANADROL
Powder: per 1 gram of Oxymetholone
Produces: Highest concentration made – 50mg/ml

Requirements:
1 gram of Oxymetholone powder
1 Beaker suitable for holding the volume of liquids
8.4ml of PEG 300
10.5ml 190 Proof Grain Alcohol

ANAVAR
Powder: per 1 gram of Oxandrolone
Produces: Highest concentration made – 20mg/ml

Requirements:
1 gram of Oxandrolone powder
1 beaker suitable for holding the volume of liquids
9.8ml of PEG 300
39.2ml of 190 Proof Grain Alcohol

ARIMIDEX
Powder: per 1 gram of Anastrozole
Produces: Highest concentration made – 5mg/ml

Requirements
1 gram of Anastrozole powder
1 beaker suitable for holding the volume of liquids
19.9ml of PEG 300
179.1ml of 190 Proof Grain Alcohol

CLOMID (Version I)
Powder: per 1 gram of Clomiphene Citrate
Produces: Highest concentration made – 50mg/ml

Requirements:
1 gram of Clomiphene Citrate
1 beaker suitable for holding the volume of liquids
7.6ml of Glycerol
11.3ml of 190 Proof Grain Alcohol

CLOMID (Version II)
Powder: per 1 gram of Clomiphene Citrate
Produces: Highest concentration made – 50mg/ml

Requirements:

1 gram of Clomiphene Citrate
1 beaker suitable for holding the volume of liquids
8.4ml of PEG 600
10.5ml of 190 Proof Grain Alcohol

DIANABOL
Powder: per 1 gram Methandrostenolone
Produces: Highest concentration made – 50mg/ml

Requirements:

1 gram of Methandrostenolone powder
1 beaker suitable for holding he volume of liquids
19ml of 190 Proof Grain Alcohol

FEMARA
Powder: per 1 gram of Letrozole
Produces: Highest concentration made – 5mg/ml

Requirements:

1 gram of Letrozole powder
1 beaker suitable for holding the volume of liquids
19.9ml of PEG 300
179.1ml of 190 Grain Proof Alcohol

NOLVADEX (Version I)
Powder: per 1 gram of Tamoxifen Citrate
Produces: Highest concentration made – 20mg/ml

Requirements:

1 gram of Tamoxifen Citrate
1 beaker suitable for holding the volume of liquids
19.6ml of Glycerol
29.4ml of 190 Proof Grain Alochol

NOLVADEX (Version II)
Powder: per 1 gram of Tamoxifen Citrate
Produces: Highest concentration made – 20mg/ml

Requirements:

1 gram of Tamoxifen Citrate
1 beaker suitable for holding the volume of liquids
9.8ml of PEG 600
39.2ml of 190 Proof Grain Alcohol

PROVIRON
Powder: per 1 gram of Mesterolone
Produces: Highest concentration made – 50mg/ml

Requirements

1 gram of Mesterolone
1 beaker suitable for holding the volume of liquids
8.4ml of PEG 300
10.5ml of 190 Proof Grain Alcohol

WINSTROL
Powder: per 1 gram of Stanozlol
Produces: Highest concentration made – 25mg/ml

Requirements:

1 gram of Stanozlol
1 beaker for holding the volume of liquids
7.8ml of PEG 300
31.2ml of 190 Proof Grain Alochol

For all of the above conversions requiring PEG and 190 Proof Alcohol, use the following procedure;
Place a sufficient amount of water in a pan and place on the stove
Remove from heat when the water reaches boiling temperature
Place the powder and the PEG in the beaker
Immerse the beaker in the pan of water so that the water is level with the top of the contents of the beaker
Gently swirl or stir the contents of the beaker until the solution is clear (reheat the water if necessary)
Remove the beaker from the water
Allow the PEG to cool down
Slowly add the 190 Proof Alcohol to the mixture
Gently stir until fully mixed.

For all of the above conversions where PEG is not required, use the following procedure;
Mix powder and 190 Proof Alcohol in the beaker
Gently swirl or stir the contents of the beaker until the solution is clear
The majority of powders which do not require PEG will dissolve readily but those that are troublesome, refer to the heating procedure as outlined above.
In the event that 190 Grain Alcohol (EverClear) is unavailable, then substitute Bacardi 151.
List of Materials:
190 Proof Grain Alcohol or Bacardi 151, PEG 300, PEG 600. Powder, beaker, stir rod, suitable container for holding finished preparation. Weighing scales accurate to 0.001g (if preparing yourself)

You never want to be in a situation where you have to shake it up to use it. While it’s good to shake a solution to ensure even distribution throughout the liquid, you should always prefer to have all of your powder dissolved and not to be able to see any crystals floating around in the liquid
Ideally you want a solution, not a suspension. If you have a preparation which is little more than powder sitting in liquid, or where after swirling it visibly falls down to the bottom of the vial, it is utterly useless for getting any kind of consistency of dosing. Anything worthy of being called a suspension should be fairly stable after shaking such that you can take your time to draw it.

Solid Fucking post!! Would you have a recipe for Aromasin? Thanks bro!

 

[Champ1988]

What about a liquid tbol recipe?

 

[Euricomiranda]

what can i add to the recipe to get rid of the shit taste?

 

[lars_helgek]

How about tadalafil and Viagra?

 

[trip0805]

Solid Fucking post!! Would you have a recipe for Aromasin? Thanks bro!

Can mct oil be used for the anavar recipe? Along with some flavoring? Like mio or Kool aid powder?

 

[Lifting88]

Can mct oil be used for the anavar recipe? Along with some flavoring? Like mio or Kool aid powder?

I was thinking the same

Every steroid is made in mct so why hot a oral powder

 

[trip0805]

I was thinking the same

Every steroid is made in mct so why hot a oral powder

I've also heard of people putting it in smoothies and other drinks. So IDK why you wouldn't be able to. But before I go wasting anavar, I want to be sure.

 

[Pinnacle Elements]

can i use PEG 600 instead of the PEG 300 and Ethanol??

will be this mix be good: ?

1 gram of Stanozlol
1 beaker for holding the volume of liquids
7.8ml of PEG 600
31.2ml of Ethanol (99%)

How about PEG400?

 

[Pinnacle Elements]

I appreciate the OP posting this great info.....but I disagree with the idea that it's better for a compound to be in a dissolved state, rather than a suspended solution. Think about it...if you have children and you go to the Pharmacy to have a script filled ...how does it come? In a suspension that must be shaking before administered! I've used Ora-Plus suspension vehicle for all of my orals. It's super easy and tastes great with a little flavoring added... I believe if the suspension is vigorously shaken before taken, the dose will be very, very accurate.

Suspensions are only made when the solubility is enough.

Oral suspensions, even shaken well, can give ~50% margin of error

 

[Qualityfirst]

Anyone have any experience with using glycerin and bacardi 151 for orals?

Yes. Mix 3 parts VG to 1 part alc. add 2 drops of essential oil peppermint and it tastes great!!

 

[Pinnacle Elements]

Started making my own topicals with these dope applicators for compounds with poor oral bioavailability/solubility

 

[mochul]

Started making my own topicals with these dope applicators for compounds with poor oral bioavailability/solubilityView attachment 292591

What is it?