Ozzy619
Well-known Member
I like his Tren A, so far so good.
I trolled over at Evo and I don't think its the same Titan
MESO-Rx
Anabolic Steroids
Titan Labs
- Thread starter Titanlabs
- Start date
I like his Tren A, so far so good.
I trolled over at Evo and I don't think its the same Titan
inkandmuscle
New Member
I can vouch for his arimidex got bloodwork back e2 is a bit high but still under control but my adex dose is pretty low (1.5mg/wk)... still don't plan on pinning the test e I have though..
insertnamehere
New Member
[QUOTE="Ozzy619, post: I trolled over at Evo and I don't think its the same Titan[/QUOTE]
I doubt we will ever know for fact but based on the timing of his arrival at Evo, coinciding with Lightspans low serum levels, and truebodybuilder89 (themyth89 at Evo) coming into the thread (at Evo) stating some blood test numbers on Titans gear before Titan re-entered the thread (at Evo) after being blasted...has me convinced.
I doubt we will ever know for fact but based on the timing of his arrival at Evo, coinciding with Lightspans low serum levels, and truebodybuilder89 (themyth89 at Evo) coming into the thread (at Evo) stating some blood test numbers on Titans gear before Titan re-entered the thread (at Evo) after being blasted...has me convinced.
inkandmuscle
New Member
What page is LS blood results on? just curious
inkandmuscle
New Member
I dont have tons of knowledge in this dept but has anybody compared these to heavyiron testing protocals on asf? doesnt seem massively underdosed according to that?? Again I'm new to this game so Im not in a good position to make a call...
confusion, confusion
weighted chinup
Well-known Member
I dont have tons of knowledge in this dept but has anybody compared these to heavyiron testing protocals on asf? doesnt seem massively underdosed according to that?? Again I'm new to this game so Im not in a good position to make a call...
confusion, confusion
Here is the post Dr.Scally made on where Serum T levels should be in relation to how much test was taken.
I know when I was on 100mg of watson test cyp my levels were in the low 400s. On 200 it was close to 900ng/dl.
So the rule of ten doesn't apply to every one. But even using my numbers as a guide, the test e was still underdosed.
So the rule of ten doesn't apply to every one. But even using my numbers as a guide, the test e was still underdosed.
inkandmuscle
New Member
the testing protocal on asf says at 4 wks on 600mg/wk with bloods 7 days after last pin should be ~2350 +/- 150
im just curious where they get this number?
somebody more educated than myself should check that protocal out and shine a light for the rest of us...
inkandmuscle
New Member
It would almost appear they base their protocal on half dosed gear??
inkandmuscle
New Member
http://anabolicsteroidforums.com/showthread.php/447-HOW-TO-TEST-Testosterone-Cypionate-or-Enanthate
insertnamehere
New Member
It would almost appear they base their protocal on half dosed gear??
ASF is a sponsored forum, so I would agree haha
Haunch
New Member
Exactly how I feel. This entire homebrew, UGL thing is discouraging to say the least
Guys the problem isn't the labs a lot of times, its the raws. You probably aren't going to get better raws then them so I don't see how homebrew is the answer.
Test e is shit across the board right now and I suggest every one switch to test cyp.
Test e is shit across the board right now and I suggest every one switch to test cyp.
Ozzy619
Well-known Member
Showstoppa is right and Millard has said the same thing before. You're always going to get problems with an UGL. Not only with raws, but a whole lot of other things. There's no regulations or QC for most labs. The only way to avoid this is don't buy from an UGL. And I too have heard Test E is shitty every where right now. Feel free to voice your opinion, but that's the truth of the matter.
lightspan
New Member
mass specs are up in the mass spec thread. test e was pretty much right where i said it would be based on my bloodwork, just over 50%. test p is clown college shit. anavar is anavar, the concentration number is pretty meaningless for solids, so no one start screaming about dosing until i can weigh one of his tabs.
Although I don't have a dog in this fight, If the problem is with the raws how does replacing them help the customer? I would think a refund should at least be an option for those who are not willing to take the chance on getting another bad batch...
Er, who is the "we" getting the 2nd MS performed? Not Titan Labs, I hope..
Similar threads
