MESO-Rx Sponsor Axle Labs - US Domestic

I had this ha

I had this happen a while ago. I ordered primo from another source I found on sst and injected as soon as it arrived. My delt swelled up over the next few days and eventually the pain and pressure was unbearable. I went to hospital and they lanced it and gave me an ABX IV. I thought my prep was just bad so I tried it again and wouldn’t you know the fever and infection came right back. I emailed the source letting them know what happened. I’ll never order from them again.

I’ve never had a single issue with axles gear I’ve been using it for months now and feel amazing.

Who was the other source ?
 
yes please share this source with the forum, i honestly don't know why people don't include said info when they post, after all this is a harm reduction forum and leaving out this source with infectious gear is mind boggling to me
I know lol. It's like someone walking into the room and saying "I just saw someone we know get hit by a car" then just leaving after that lol
 
yes please share this source with the forum, i honestly don't know why people don't include said info when they post, after all this is a harm reduction forum and leaving out this source with infectious gear is mind boggling to me
For me it was QSC, but there's no additional infection anywhere else after injecting the same stuff again.
 
For me it was QSC, but there's no additional infection anywhere else after injecting the same stuff again.
I’m actually going to start giving Axle another shot. With QSC I only use about half of each vial because I eventually see pieces of the rubber stopper in the oil.
 
I’m actually going to start giving Axle another shot. With QSC I only use about half of each vial because I eventually see pieces of the rubber stopper in the oil.
Axle Labs has the best quality vials I’ve ever seen in the industry. I was actually quite surprised by their vial quality. It’s top notch.

QSC’s vials and stoppers are just outright garbage. You need to buy 10 mL vials, 10 mL syringes, and just load everything into them and transfer to the better vials.

If my bloodwork comes out good, I’m happy to pay a premium for better vials, labeling and filtering so I don’t accidentally take Tren and have sex with Senior citizens… no matter how fine somebody’s grandma looks.

This isn’t an endorsement of Axle Labs or any swearing off of other sources like QSC whom I’ll still buy from sometimes. I just like to keep my options open and not put all my eggs in one basket. And at this time, Axle’s gear is exactly what I need.
 
Last edited:
Axle Labs has the best quality vials I’ve ever seen in the industry. I was actually quite surprised by their vial quality. It’s top notch.

QSC’s vials and stoppers are just outright garbage. You need to buy 10 mL vials, 10 mL syringes, and just load everything into them and transfer to the better vials.

If my bloodwork comes out good, I’m happy to pay a premium for better vials, labeling and filtering so I don’t accidentally take Tren and have sex with Senior citizens… no matter how fine somebody’s grandma looks.

This isn’t an endorsement of Axle Labs or any swearing off of other sources like QSC whom I’ll still buy from sometimes. I just like to keep my options open and not put all my eggs in one basket. And at this time, Axle’s gear is exactly what

Axle Labs has the best quality vials I’ve ever seen in the industry. I was actually quite surprised by their vial quality. It’s top notch.

QSC’s vials and stoppers are just outright garbage. You need to buy 10 mL vials, 10 mL syringes, and just load everything into them and transfer to the better vials.

If my bloodwork comes out good, I’m happy to pay a premium for better vials, labeling and filtering so I don’t accidentally take Tren and have sex with Senior citizens… no matter how fine somebody’s grandma looks.

This isn’t an endorsement of Axle Labs or any swearing off of other sources like QSC whom I’ll still buy from sometimes. I just like to keep my options open and not put all my eggs in one basket. And at this time, Axle’s gear is exactly what I need.
Yessir I’d have to agree. I was pretty impressed with the vials from axle. Especially after getting leaky bullshit from muscle candy
 
For me it was QSC, but there's no additional infection anywhere else after injecting the same stuff again.
It's very easy to push bacteria on your skin into your muscle tissue when pinning, Especially MRSA/any staph, strep, pseudomonas, and Candida (fungus) which are all native to our skin.. it's why you want to make sure to alcohol swab everything, and not blow on the swabbed area to dry it, only ever let it slowly air dry. Make sure to get the vial top too.

I've given myself infections requiring an I&D surgery and inpatient IV antibiotics on a couple occasions with otherwise clean material because I was too rushed and didn't do everything I should have to be sterile.

Even if you're totally sterile, the room/environment you're in plays a big role too. You couldn't pay me to pin in a any unsanitary environment, and especially never a communal bathroom, locker room, or anywhere with a lot of animals in it.

I only pin in my master bathroom or my workshop/office where I have a halfway decent lab setup with flowhoods and such. Both rooms I keep immaculately clean and no one else is in them.

It might be overkill but I haven't given myself an infection now in 7 years and I pin a lot of stuff on a daily basis. Glutathione, carnitine, peptides, hrt, etc.
 
Last edited:
Placed first order with Axle Labs. Their web site is basic, but it works well overall. I will keep everyone posted on the basics. An overall opinion on the gear will take some time.
 
It's very easy to push bacteria on your skin into your muscle tissue when pinning, Especially MRSA/any staph, strep, pseudomonas, and Candida (fungus) which are all native to our skin.. it's why you want to make sure to alcohol swab everything, and not blow on the swabbed area to dry it, only ever let it slowly air dry. Make sure to get the vial top too.

I've given myself infections requiring an I&D surgery and inpatient IV antibiotics on a couple occasions with otherwise clean material because I was too rushed and didn't do everything I should have to be sterile.

Even if you're totally sterile, the room/environment you're in plays a big role too. You couldn't pay me to pin in a any unsanitary environment, and especially never a communal bathroom, locker room, or anywhere with a lot of animals in it.

I only pin in my master bathroom or my workshop/office where I have a halfway decent lab setup with flowhoods and such. Both rooms I keep immaculately clean and no one else is in them.

It might be overkill but I haven't given myself an infection now in 7 years and I pin a lot of stuff on a daily basis. Glutathione, carnitine, peptides, hrt, etc.
I think part of the problem is my incredibly hairy legs. This may make it harder for me to properly clean, but I scrubbed 3 alcohol wipes on my quads for a while prior to injecting. My office is also clean.

No issues with glute injections so far. I really don’t like quad injections. This always happens to varying degrees, but this time it’s the worst.
 
It's very easy to push bacteria on your skin into your muscle tissue when pinning, Especially MRSA/any staph, strep, pseudomonas, and Candida (fungus) which are all native to our skin.. it's why you want to make sure to alcohol swab everything, and not blow on the swabbed area to dry it, only ever let it slowly air dry. Make sure to get the vial top too.

I've given myself infections requiring an I&D surgery and inpatient IV antibiotics on a couple occasions with otherwise clean material because I was too rushed and didn't do everything I should have to be sterile.

Even if you're totally sterile, the room/environment you're in plays a big role too. You couldn't pay me to pin in a any unsanitary environment, and especially never a communal bathroom, locker room, or anywhere with a lot of animals in it.

I only pin in my master bathroom or my workshop/office where I have a halfway decent lab setup with flowhoods and such. Both rooms I keep immaculately clean and no one else is in them.

It might be overkill but I haven't given myself an infection now in 7 years and I pin a lot of stuff on a daily basis. Glutathione, carnitine, peptides, hrt, etc.
You do realize the world health organization doesn't even recommend swabbing the skin prior to injecting right?

This idiot pinned 2ml with a 1/2 needle in his quad, then his knew swelled. It's called a sub q leak.

Shockingly like most of his claims. He has zero proof of any infection or even hospitalization
 
You do realize the world health organization doesn't even recommend swabbing the skin prior to injecting right?

This idiot pinned 2ml with a 1/2 needle in his quad, then his knew swelled. It's called a sub q leak.

Shockingly like most of his claims. He has zero proof of any infection or even hospitalization
why do you talk to people like that
 
why do you talk to people like that
Take a look at all his wild, fantasy claims on this forum. He makes up a bunch of nonsense then repeatedly asks for help when he keeps proving himself a noob, or a liar. It damages the reputation of vendors with his false claims of infections and the purity of gear based on air bubbles. He IS an idiot.

Don't make claims without evidence
 
Take a look at all his wild, fantasy claims on this forum. He makes up a bunch of nonsense then repeatedly asks for help when he keeps proving himself a noob, or a liar. It damages the reputation of vendors with his false claims of infections and the purity of gear based on air bubbles. He IS an idiot.

Don't make claims without evidence
Hmm good point
 
Hmm good point
Not really. This guy is a narcissistic idiot who makes shit up on the fly to support his case. I'll spell it out for you.

1. If you read anything in my posts, you'll see multiple times that I'm not claiming infection from ANY vendor because I don't have reliable proof, but that it may be possible, and also that it may be something else entirely. Yes, it was and is an infection. I ended up in the hospital. This is a harm reduction board, not Anabolex.

2. I've never injected 2mL of any steroid at any given time, nor will you find any claims about me doing it. I'm doing 2x weekly injections, which means 1mL in one place, 1mL in another place. 1ml of Test C 300, 1ml of Deca 200. This is spelled out in my log.

3. This guy claims I said that I gained 70+ lbs of muscle in 1 year. I never claimed that. I claimed it in 1.5 years of eating 10k+ calories a day and cycling several times. I have a decked out $70k home gym and am commited to lifting. At 6'10", I gain considerably more mass than your average person because it scales differently. This dude is 5'5" and 150lbs and mad as fuck because he's a twink.

4. It is not a subq leak. It's literally a staph infection in my knee, as confirmed with multiple tests in the hospital, but he just wants to be mad and make shit up.

5. Of fucking course I ask for help here. This is a harm reduction forum. We are all sharing our knowledge with each other. I am not as knowledgeable as some folks, so yes, I do ask for help and guess what? I'm not ashamed. How did this idiot make that into an actual issue? Yes, I am a newbie, and stated this many times. Again, I am not ashamed because I'm here to learn.

6. He's constantly taking everything out of context, dialing back numbers, and making shit up nonstop. He's not a useful contributor to Meso, he's a troll and a QSC dickrider.

7. What he's not telling you is that I, like many others, found actual white floaters in my QSC gear (which seemed to have dissolved shortly after arriving). There's a bunch of users talking about QSC's filter failures, and even QSC's Tracy telling users that they're not refunding orders with floaters (filter fibers). QSC even went ahead and intentionally sold the bad oils in a "sale" to get rid of them, and said they'll fix the problem going forward. QSC also refused to answer if my Semaglutide shipment was affected by their recent peptide pH issue. This source, while they often produce quality compounds, is sometimes shady as fuck.

8. I repeatedly stated that this infection may be caused by something else since I've since injected the same bottle of QSC's Deca 200 and Axle Lab's Test C 300 and have yet to develop another infection.

How am I damaging the reputation of any sources here? I'm not.

I'll give you a hint: Martin is a useless troll who latches on to every post I make and tries to talk shit because he's a QSC dickrider who doesn't care about limiting harm. I have him on ignore, like many members here.
 
Last edited:
Back
Top