MESO-Rx
Anabolic Steroids
Qingdao Sigma Chemical Co., Ltd (International, US, EU, Canada and Australia domestic
- Thread starter Qingdao Sigma Chemicals
- Start date
AlexDavis43
Member
Love the camaraderie
How about superdrol? Thinking of kicking off my bulk with it. Test deca superdrol.
I've done 20mg for 4 weeks. I get big and strong fast. But strangely I bloat. Some say superdrol doesn't bloat but I definitely bloat on it.
I'm thinking of doing 10mg and maybe push it to 5 (dare I 6?) weeks.
BuildABro
Member
Longer acting Tren ester with a less pronounced side effect profile from what I have read on the subject. Yes, a more expensive option, but I got a kit from Tracy’s last promo for 150 bucks, so still pretty cost effective
BuildABro
Member
I still have about 200caps lying somewhere but I’m hesitant to use it since it jacks up my systolic pressure by 20pts as soon as it kicks in lol.
strongfam213
New Member
I know, I know, you can't 100% rely on oil color. Different carrier oils, different recipes, etc. But! I can tell you after seeing many batches of QSC mast and test over the years. The mast is always clear, with the smallest amount of lime green, but almost clear. Like a florescent clear if that makes sense. His test is always a mild yellow tint. Nothing like tren. Like a clearer version of the color of fresh lime juice (not concentrate).
AlexDavis43
Member
Fortunately Superdrol cycles don't last very long.
Whats the longest you've run it for? I usually stick to 4 weeks.
BuildABro
Member
Same, 4 weeks. I worry about the hepatotoxicity factor. Though shockingly my testing post cycle was not all that concerning. I guess I must have just gotten lucky in the generics lotto on that one.
Grey Spartan
Member
You are correct.
This will be fun. I'm still waiting on mine from the oil promo?! I think Tracy is sending my by skateboard, uphill, from China. Do skateboards float?
BuildABro
Member
I already threw some labels on mine. Worst case scenario, I can always float you a vial to tide you over if Q is monumentally slow.
Dude, that label is so professional, we need the qsc naked chick logo again lol
Do you use tudca or anything while on it?
BuildABro
Member
I did not, no. Test base of course, and then fish oil and glutathione. I ran a full bore PCT afterwards also, but it almost did not even seem necessary
Ghoul
Member
Last edited:
Ghoul
Member
-Peptides often clump into aggregates.
-Aggregates can induce side effects, and immunity to the peptide.
-The correct filter easily removes the largest aggregates that cause the most problems.
The critics: "Shut up, shut up! This probably never happens and if it does it's so rare it doesn't matter and it's stupid to bring it up!"
Then why do you care about dimer in HGH?
Dimer is aggregation.
If aggregation doesn't matter, why do you demand testing for dimer in HGH?
-Aggregates can induce side effects, and immunity to the peptide.
-The correct filter easily removes the largest aggregates that cause the most problems.
The critics: "Shut up, shut up! This probably never happens and if it does it's so rare it doesn't matter and it's stupid to bring it up!"
Then why do you care about dimer in HGH?
Dimer is aggregation.
If aggregation doesn't matter, why do you demand testing for dimer in HGH?
Last edited:
Must be a pain in the ass tho, I can see it is usually brewed only at 100mg and not over.
At least tren E can be easily brewed at 200mg/ml.
Not that it matters much as 300/350mg is usually what I believe the max dosage one should use but still. It's 3/3.5ml Vs 1.5ml
I like low volume of injections so I'll probably stick with the Enant
Even so I'll gather info if the hex can be brewed without pip at higher concentration
@narta any idea?
Similar threads
