[Source] Sasquatch Labs - Intro/Sale (US Domestic)

[SouthernFryed]

@warlord55 I will say it leaves a lump for quite a while, but they move down lower in my quad and go away in a few days.[/QUOTE]

The only thing I ever noticed from MCT was a lump the first time I pinned my glute. I attributed it to pushing the oil too fast. I warm the oil and inject slowly, and haven’t had any lumps since. Mind you, that’s never injecting more than 1ml per pin. FWIW

 

[warlord55]

@warlord55 I will say it leaves a lump for quite a while, but they move down lower in my quad and go away in a few days.

The only thing I ever noticed from MCT was a lump the first time I pinned my glute. I attributed it to pushing the oil too fast. I warm the oil and inject slowly, and haven’t had any lumps since. Mind you, that’s never injecting more than 1ml per pin. FWIW[/QUOTE]
How do you go about heating it? Do you just put the vial in warm water for a bit?

 

[WhiteHotWombat]

The only thing I ever noticed from MCT was a lump the first time I pinned my glute. I attributed it to pushing the oil too fast. I warm the oil and inject slowly, and haven’t had any lumps since. Mind you, that’s never injecting more than 1ml per pin. FWIW

How do you go about heating it? Do you just put the vial in warm water for a bit?[/QUOTE]
I usually use the wife's hair dryer to warm my gear

 

[Bigboy727]

Well it’s been 10 days since my pack was supposedly shipped and I got nothing. I emailed them twice with no response. I cannot say for certain if it was mailed or not because I didn’t get a tracking number. Take it for what it’s worth because it was not a small order.

 

[Skull]

Well it’s been 10 days since my pack was supposedly shipped and I got nothing. I emailed them twice with no response. I cannot say for certain if it was mailed or not because I didn’t get a tracking number. Take it for what it’s worth because it was not a small order.

Never order more than you can afford to lose. Hope everything gets to you safely bro. Id like to see all the HPLC/ MassSpecs on "ALL" of @Sasquatch Labs raws before rewing each an every batch before i would ever even think about ordering from this source.

 

[Bigboy727]

Never order more than you can afford to lose. Hope everything gets to you safely bro. Id like to see all the HPLC/ MassSpecs on "ALL" of @Sasquatch Labs raws before rewing each an every batch before i would ever even think about ordering from this source.

I am fortunate that I have a great paying job. I ordered extra to send off to see what this lab was about. I figured I would do that for your the community being I have the means. If any lab was on the up and up sure they wouldn’t be expecting there customers to have there gear tested but do it themselves to make sure there customers are safe.

 

[Evom1]

I am fortunate that I have a great paying job. I ordered extra to send off to see what this lab was about. I figured I would do that for your the community being I have the means. If any lab was on the up and up sure they wouldn’t be expecting there customers to have there gear tested but do it themselves to make sure there customers are safe.

Awesome of you to do so

 

[WhiteHotWombat]

Well it’s been 10 days since my pack was supposedly shipped and I got nothing. I emailed them twice with no response. I cannot say for certain if it was mailed or not because I didn’t get a tracking number. Take it for what it’s worth because it was not a small order.

I was about to place another order but I think I'll hold off until I see how this plays out. Hopefully it's on it's way.

 

[SouthernFryed]

The only thing I ever noticed from MCT was a lump the first time I pinned my glute. I attributed it to pushing the oil too fast. I warm the oil and inject slowly, and haven’t had any lumps since. Mind you, that’s never injecting more than 1ml per pin. FWIW

How do you go about heating it? Do you just put the vial in warm water for a bit?[/QUOTE]

I use a hair dryer. Only takes a few seconds. I hold the barrel of the syringe in my hand and let the heat even out, then put it in the web between my index and pointer finger of my other hand to check the temperature. I like for it to be just barely discernibly warm.

 

[SouthernFryed]

Well it’s been 10 days since my pack was supposedly shipped and I got nothing. I emailed them twice with no response. I cannot say for certain if it was mailed or not because I didn’t get a tracking number. Take it for what it’s worth because it was not a small order.

Hopefully your pack got sent out late and is stuck in the holiday congestion. I don’t remember these guys saying anything about shutting down for Xmas.

Although I have to admit it’s a bit disconcerting that they haven’t been active since last Sunday....

 

[FiEnD]

Hopefully your pack got sent out late and is stuck in the holiday congestion. I don’t remember these guys saying anything about shutting down for Xmas.

Although I have to admit it’s a bit disconcerting that they haven’t been active since last Sunday....

With any customer service at all he should be able to get an answer instead of being left hanging. That's bullshit. Especially for a domestic source

 

[Bigboy727]

I was about to place another order but I think I'll hold off until I see how this plays out. Hopefully it's on it's way.

Haven’t heard or seen from the squatch in 4 days and have emails and everything to prove this that I got verification of being mailed on the 14th. It definitely could be the usps fault but I still don’t have anything today. I just want everyone to know to calm down so there isn’t 20 or us going through the ringer. I will give them the benefit of the doubt before going to the extent of completely sabotaging there operation on Meso. I’m hoping they just been busy.

 

[Skull]

I am fortunate that I have a great paying job. I ordered extra to send off to see what this lab was about. I figured I would do that for your the community being I have the means. If any lab was on the up and up sure they wouldn’t be expecting there customers to have there gear tested but do it themselves to make sure there customers are safe.

Thank you very much for yoyr contributions brother. It means alot to all of us. Much respect brother. We the community owes you a debt of gratitude for doing so. Once again thank you an well all be anxiously awaiting the outcome. Sasquatch may have a few tests done that i seen in the beginning of this thread but we all know that he isn't testing everyting he gets an it shows by him not posting up HPLC/MassSpecs on "ALL" his raws. Shit that should be a drop in the bucket for any source. Im still dumb founded at tye fact that all these sources an homebrewers have tye major advantage of being able to test their raws before brewing from analyzer yet do not do it smfdh. For @Sasquatch Labs sake, he better hope to hell he has a good powder connect.....for the batch your testing anyways lol....Since we all know each an every batch of raws is not created equal

 

[Bigboy727]

Thank you very much for yoyr contributions brother. It means alot to all of us. Much respect brother. We the community owes you a debt of gratitude for doing so. Once again thank you an well all be anxiously awaiting the outcome. Sasquatch may have a few tests done that i seen in the beginning of this thread but we all know that he isn't testing everyting he gets an it shows by him not posting up HPLC/MassSpecs on "ALL" his raws. Shit that should be a drop in the bucket for any source. Im still dumb founded at tye fact that all these sources an homebrewers have tye major advantage of being able to test their raws before brewing from analyzer yet do not do it smfdh. For @Sasquatch Labs sake, he better hope to hell he has a good powder connect.....for the batch your testing anyways lol....Since we all know each an every batch of raws is not created equal

Thank you very much for yoyr contributions brother. It means alot to all of us. Much respect brother. We the community owes you a debt of gratitude for doing so. Once again thank you an well all be anxiously awaiting the outcome. Sasquatch may have a few tests done that i seen in the beginning of this thread but we all know that he isn't testing everyting he gets an it shows by him not posting up HPLC/MassSpecs on "ALL" his raws. Shit that should be a drop in the bucket for any source. Im still dumb founded at tye fact that all these sources an homebrewers have tye major advantage of being able to test their raws before brewing from analyzer yet do not do it smfdh. For @Sasquatch Labs sake, he better hope to hell he has a good powder connect.....for the batch your testing anyways lol....Since we all know each an every batch of raws is not created equal

Yeah from just what ppl is going through I think we definitely need to watch out for each other. Sucks my order from them is tainted but was very speedy and now I may have gotten jacked.(tbd) We need a meso only lab.

 

[FCKY11c]

Was really hoping this lab would prove everyone wrong.. but as of the last few days they’ve been going down hill fast!

 

[Bigboy727]

Turns out the squatch hasn’t checked in since last Sunday at 1:46pm to this thread. Something to think about how serious he may take this.

 

[Gbro]

It sounds like he came in and scammed the board for Christmas presents.

 

[WhiteHotWombat]

It sounds like he came in and scammed the board for Christmas presents.

I blame Becca and those sweet ass tits. Fucking sold me - now I'm worried I'm pinning cooking oil in my thigh.

 

[Bigboy727]

I blame Becca and those sweet ass tits. Fucking sold me - now I'm worried I'm pinning cooking oil in my thigh.[/QUOTE
Sasquatch is gone brother

She gone

 

[Slammich]

She gone

That's too bad. I had already developed feelings for her. Thought she was "the one".