I'd like to see it in an oral solution.Thank you.
Please consider shooting for 5mg! That way the dose can be split. Wife and I have tried both approaches and most women will do better at 5mg am 5 mg pm
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I'd like to see it in an oral solution.Thank you.
Please consider shooting for 5mg! That way the dose can be split. Wife and I have tried both approaches and most women will do better at 5mg am 5 mg pm
I doubt it was that crashed when I took out the sample. Breaking the seal probably caused it to crash more. When the vial was not agitated the liquid was more clear and you could see crystals on the side of the vial but it was harder to see in a picture. Once again, speculation.Why would you send a sample from a vial that looked like that? OCD and all.
I’m cooperating with you. I’m feeding you the answers you need to give. I’ve been right with my advice so far.
Present shit positive and without thinking.
And go ahead and use me as the lightening rod. There’s 10 other guys that said the same shit I did.
You’d look better graciously thanking us instead of the bulkshit “stooooop gaslighting me...” Especially since it’s not gaslighting. Keep it up and I’ll show you what gaslighting really is.
I'd like to see it in an oral solution.
If you can’t notice something like that how do you expect to notice floaters. how are we supposed to Trust you to take the level of attention to detail we should all expect to produce sterile safe gear?
Please refer to my above post.If you can’t notice something like that how do you expect to notice floaters. how are we supposed to Trust you to take the level of attention to detail we should all expect to produce sterile safe gear?
My DHB crashes sometimes. I heat it back up in the oven, shake the crap out of it and it goes back in solution.New information regarding DHB. When submitting the samples I randomly grab a vial out of my storage. These vials are saved. When consulting with Jano about the result he brought up that if the DHB crashed at some point it would have negatively effected the results. After reading the email I checked on the vial of DHB used for the test. It had crashed. It is likely that negatively effected the results.
Crashing is pretty common for DHB and I brew mine with the absolute minimum amount of solvents to keep it suspended. Brewing it like this turns a compound that is known for its heavy pip into a compound that has very little or no pip upon injection.
EDIT: I will be taking further steps to confirm the results. I would recommend making sure your DHB is fully suspended before injection.
I do not know if it was crashed when I drew the sample. Before agitating it the crystals were set along the side of the so the liquid was closer to clear and so were the crystals. There are different possibilities but I will say this - I would know for sure if I had raw testing on the DHB and this would have been avoided.My DHB crashes sometimes. I heat it back up in the oven, shake the crap out of it and it goes back in solution.
But I think what you're saying is if you drew from a vial that was crashed you would have a lower milligram amount. Why wouldn't you have checked that before you drew the sample?
Because I know how intelligent you are. Some of these guys are just feeding off you. I have to move around throughout the day and I am not always able to respond in 15 seconds. It took about 15 minutes of me not being able to answer for things to spiral into putting words into my mouth. I had facts, I presented them, and I said I am figuring out what is going on. Some people in this thread start creating their own stories if I do not answer immediately and thats exactly why there is so much misinformation in here. The real information gets buried.
Give me a little bit of time.
Credit is still on the table. I also thought of the possibility of replacing vials if asked and that would be pretty easy to do If I know that my DHB is under dosed. With the introduction of new information, if I was asked for new vials by customers disappointing with the results, my rebrew may be 100mg/ml IF it was under dosed, or if it wasn't under dosed my DHB comes out to 145mg/ml.@MaskedLiberty basically handed you the best way to have handled this except I would've added a raw sample. Had you just initially figured out a fair credit to those you sold it to and then sent out testing this would already be put to bed. It'd be a minimal loss for future gains. It's not like you have to replace all vials because you sent pure oil.
Are you really that dense?
You have made many posts since the picture was requested, but you continue to avoid the requested picture..
If you are not able to post a picture right now than say it..
At least acknowledge the request..
instead of giving excuses why you haven't done so..
It wasn't 15minutes after I posted that when the rumor mill and speculation began. I'm sorry, I cannot respond 24/7. After this message I HAVE to get back to work.Stop blaming @BigBaldBeardGuy for inciting this mess!
If you've been reading, it has been repeatedly said..
"Judging by the way YOU have responded throughout this thread"
Meaning your reactions (or non reactions) have caused people to have no faith(distrust) in you..
Bringing them to use their imaginations when you don't respond correctly, which unfortunately (for you) are where these "stories" are coming from.
You gotta own some of this yourself!
I posted that before reading three pages about this subject. Seems it's already been beaten to death.I do not know if it was crashed when I drew the sample. Before agitating it the crystals were set along the side of the so the liquid was closer to clear and so were the crystals. There are different possibilities but I will say this - I would know for sure if I had raw testing on the DHB and this would have been avoided.
test the raws prior to rebrewing a larger batch.Credit is still on the table. I also thought of the possibility of replacing vials if asked and that would be pretty easy to do If I know that my DHB is under dosed. With the introduction of new information, if I was asked for new vials by customers disappointing with the results, my rebrew may be 100mg/ml IF it was under dosed, or if it wasn't under dosed my DHB comes out to 145mg/ml.
Exactly where I am at.t
test the raws prior to rebrewing a larger batch.
It is important to know if it is 100mg/ml or 145mg/ml, thats a damn huge difference..
very good.Exactly where I am at.
There is so much content in here I don't blame anyone for getting confused.very good.
i guess i missunderstood your post then because i have thought you rebrew prior to it and either it will be 100 if it is no issue with the raws or it is 145 if raws are underdosed..
It wasn't 15minutes after I posted that when the rumor mill and speculation began. I'm sorry, I cannot respond 24/7. After this message I HAVE to get back to work.
Please contact me if you bought Viagra. I would like to fix it.
Customers with concerns with their DHB purchase can contact me as well and we can workout a solution if you are unhappy with what you received. I will be verifying the DHB result and figuring out exactly what happened.
If you are referring to the label I literally grab a random vial for these tests. I still have vials of DHB with the old label. I could have changed it for the picture but that felt wrong?
Perhaps you should try reading my responses.That's the reaction that was expected from you.
ZERO RESPONSIBILITY!
It may take YOU 15mins to think about something, but other people's minds start to work immediately..
You keep saying that "you can't respond 24/7" but you have been here posting the whole time so that is obviously not the issue.
I think your right.. you need a customer service rep.. one with people skills..
Because much like brewing consistent, reliably dosed gear this is obviously NOT something you're good at!