MESO-Rx

Anabolic Steroids

TSL LABS

I've heard of some people actually preferring cloudy tren. Think the ba causes that. If too much added, but don't quote me on this, just something that came to thought. You can, however, quote me on seeing people prefer cloudy tren[emoji16]


Sent from my iPhone using Tapatalk
 
Kel995 said:
Would make sense, his shit has been potent so far. Going by feel of his Prop, but no kidding, 5 days of PIP going 1.5 into the glute.

Cialis is definitely good.
Click to expand...

I certainly don't question the potency. Hmm... I wonder, now, if it's the prop causing the PIP.
 
Prop went in Solo. 1.5cc with a 25gx1.5 into left glute. Pain came about 24 hours later, was annoying at 48 hours, and was just a bruise feeling for the next two days.
 
Weston said:
I certainly don't question the potency. Hmm... I wonder, now, if it's the prop causing the PIP.
Click to expand...
Split them up and inject individually. First tren a I ever injected had the worst pip out of anything I've ever ran. I started at .3 ml and it crippled me for days. Tsl mastren should have more pip than regular tren a. At least I would think so. At .5 ml 50mg each there's a slight pip but not bad.
 
Roger rabbit said:
I've heard of some people actually preferring cloudy tren. Think the ba causes that. If too much added, but don't quote me on this, just something that came to thought. You can, however, quote me on seeing people prefer cloudy tren[emoji16]


Sent from my iPhone using Tapatalk
Click to expand...
The ba doesn't cause the cloudy. More ba is not better. Actually the opposite. People saying they prefer cloudy tren are idiots. Most likely cloudy means it's crashed or water in the oil. Why would somebody prefer that? I know it's not you saying that so I'm not directing my post at you, just in reply to what you've heard.
 
XKawN said:
The ba doesn't cause the cloudy. More ba is not better. Actually the opposite. People saying they prefer cloudy tren are idiots. Most likely cloudy means it's crashed or water in the oil. Why would somebody prefer that? I know it's not you saying that so I'm not directing my post at you, just in reply to what you've heard.
Click to expand...

There reasoning was they felt like it was the best tren they ever had. But here is a explanation I found with a quick search but again, I am no expert in this field.
.


"This is an issue of post production precipitation, (i.e. after filtration and bottling, sterilizing...). ALL labs have been fighting Tren Ace precipitation for years.

My firm suspicion is that this is a result of an incomplete estrification reaction on the part of the Chinese. There is likely (this is again unconfirmed) some amount of Trenbolone base in the Tren Ace. The Tren base is solubilized during production and a clear solution is bottled. Some time later the far less soluble Tren base begins to precipitate out of solution.

No one has ever had a reaction to the precipitate, (other than the visual reaction of 'WTF is this'), the precipitate physiologically safe and compatible. This lends further credence that Tren base is the culprit.

When increased co-solvency is applied to the solution, the appearance of the precipitate is vastly reduced and/or eliminated. This again tells us that there is a low solubility compound in the Tren Ace that can remain solubilized under extra-ordinary conditions...very likely Tren base.

The amount of Tren base will vary from each multi kilo batch the Chinese produce."

Another major cause for sedimentation/crystallization is "crashing" gear. This is where the temperature drops below the saturation point of the mixture, and the chemicals fall out of solution from each other.


Sent from my iPhone using Tapatalk
 
Roger rabbit said:
There reasoning was they felt like it was the best tren they ever had. But here is a explanation I found with a quick search but again, I am no expert in this field.
.


"This is an issue of post production precipitation, (i.e. after filtration and bottling, sterilizing...). ALL labs have been fighting Tren Ace precipitation for years.

My firm suspicion is that this is a result of an incomplete estrification reaction on the part of the Chinese. There is likely (this is again unconfirmed) some amount of Trenbolone base in the Tren Ace. The Tren base is solubilized during production and a clear solution is bottled. Some time later the far less soluble Tren base begins to precipitate out of solution.

No one has ever had a reaction to the precipitate, (other than the visual reaction of 'WTF is this'), the precipitate physiologically safe and compatible. This lends further credence that Tren base is the culprit.

When increased co-solvency is applied to the solution, the appearance of the precipitate is vastly reduced and/or eliminated. This again tells us that there is a low solubility compound in the Tren Ace that can remain solubilized under extra-ordinary conditions...very likely Tren base.

The amount of Tren base will vary from each multi kilo batch the Chinese produce."

Another major cause for sedimentation/crystallization is "crashing" gear. This is where the temperature drops below the saturation point of the mixture, and the chemicals fall out of solution from each other.


Sent from my iPhone using Tapatalk
Click to expand...


So, when the tren is produced with the acetate ester, during post production in the lab making the raws somehow the ester falls out? Due to missing steps in the production process? Or when the injectable is produced, because of poor production of the raws, some of the acetate ester falls out and now you have a mixture of tren ace and tren no ester?

Sounds like that's made up by some ugl to satisfy unhappy customers do to the gear crashing. Not that crashing is a fuck up by the ugl. It's just a way of life. Weather gets cold gear can tend to crash.


Trust me, the gear has either crashed or water from precipitation during the brewing process. Nothing to do with losing the ester.
 
XKawN said:
So, when the tren is produced with the acetate ester, during post production in the lab making the raws somehow the ester falls out? Due to missing steps in the production process? Or when the injectable is produced, because of poor production of the raws, some of the acetate ester falls out and now you have a mixture of tren ace and tren no ester?

Sounds like that's made up by some ugl to satisfy unhappy customers do to the gear crashing. Not that crashing is a fuck up by the ugl. It's just a way of life. Weather gets cold gear can tend to crash.


Trust me, the gear has either crashed or water from precipitation during the brewing process. Nothing to do with losing the ester.
Click to expand...

My closet is cold in winter and some of my pharm crashes. Some doesn't.
 
XKawN said:
So, when the tren is produced with the acetate ester, during post production in the lab making the raws somehow the ester falls out? Due to missing steps in the production process? Or when the injectable is produced, because of poor production of the raws, some of the acetate ester falls out and now you have a mixture of tren ace and tren no ester?

Sounds like that's made up by some ugl to satisfy unhappy customers do to the gear crashing. Not that crashing is a fuck up by the ugl. It's just a way of life. Weather gets cold gear can tend to crash.


Trust me, the gear has either crashed or water from precipitation during the brewing process. Nothing to do with losing the ester.
Click to expand...

Wasn't from a ugl. It was from someone who had cloudy gear. I edited out his story cuz it was lengthy. Just put in the section about why he thinks it does what it does.


Sent from my iPhone using Tapatalk
 
Roger rabbit said:
What is making you worried? Or reason to believe you need a antibiotic


Sent from my iPhone using Tapatalk
Click to expand...
Pinned 1.5cc into left quad 2 days ago. Can hardly bend my leg, very painful, and instead of just the upper quad being tender, it moved to right above my knee and very swollen.
 
MGainz said:
Pinned 1.5cc into left quad 2 days ago. Can hardly bend my leg, very painful, and instead of just the upper quad being tender, it moved to right above my knee and very swollen.
Click to expand...

Is it warm to touch? Is it getting hard? Is water forming under skin? Is skin red?


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.

Similar threads

Arail
Arail Pharmaceuticals - US Domestic
2 3 4
Replies
72
Views
5K
readalot
readalot
Redmond Pharmacy
REDMOND PHARMACY – JANOSHIK LAB TESTS RESULTS
Replies
14
Views
378
FastBun
F
Olympian Pharmaceutical
Olympian Pharmaceutical Janoshik Lab Reports
Replies
3
Views
166
TTren
T
Arail
Arail Pharmaceuticals - Finished Product Lab Results
Replies
1
Views
181
Vajfan
V
W
I'm surprized that guys are paying $20 for a bottle of tren!!
2
Replies
21
Views
2K
brutalbuilt
brutalbuilt

Sponsors

Latest posts

Back
Top