Pristine Anabolics Intro

The difference is TGI stays informed. Pristine starts having issues, guess what happens? TGI immediately starts verifying everything on his end to ensure he doesn’t have the same quality issues. The rubber stoppers were a complaint by one person and never confirmed. And he’s actually present in his thread when things go awry.

You shouldn’t even be comparing these two sources at this point. These aren’t small mistakes on Pristine’s end. This is continuing to happen over and over, so the trust portion is going out the window. Even now, he hasn’t been present in the thread. And you can guarantee he’s aware of what’s going on.
Fair enough.

And I’ll refrain from giving any more benefit of the doubt to this cat because his lack of attention to this matter is dog shit.
 
It’s not me comparing. This has nothing to TGI

His mess ups are getting more and more
Consistent. Where do we draw the line

That's the $64,000 question.

PPL had his domestic supplier busted.
He's still slinging raws like it never happened

Titter had overdosed gear and a single incident of a floater.
No one said a single negative word.

ARL had two underdosed tests and a piss poor attitude.
Torches are lit and ready to burn.

Venom was wanted out before test results even came back.
Torces were lit from day 1.

Pharmasourse can't dose properly to save his life.
No one seemed to give much of a shit.

Hilma fucked up with low fill levels and (anecdotally) bunk Clen. They're cool to stay.

Anabolic Store pissed off a customer regarding a refund.
Torches are lit and ready to burn.

There is no standard. The bar for acceptable fuckups changes with each source and how well they're liked by the loudest mouths of Meso.
 
That's the $64,000 question.

PPL had his domestic supplier busted.
He's still slinging raws like it never happened

Titter had overdosed gear and a single incident of a floater.
No one said a single negative word.

ARL had two underdosed tests and a piss poor attitude.
Torches are lit and ready to burn.

Venom was wanted out before test results even came back.
Torces were lit from day 1.

Pharmasourse can't dose properly to save his life.
No one seemed to give much of a shit.

Hilma fucked up with low fill levels and (anecdotally) bunk Clen. They're cool to stay.

Anabolic Store pissed off a customer regarding a refund.
Torches are lit and ready to burn.

There is no standard. The bar for acceptable fuckups changes with each source and how well they're liked by the loudest mouths of Meso.
Damn....well said
 
Ok well I looked back through this shit to see if I could make better sense of it all.
@janoshik correct me here if I’m wrong...

I kept thinking why would Jano go through all this? What would he get from it? Why, why, why? Lol

Well from reading back from when this all started this morning I think I may have found out why, or I misinterpreted it, but I don’t think I did.

Jano’s suspicions didn’t start with @Trenity ‘s wrong doings. It was @Weights & Measures that he was questioning.
He was trying to see if W&M was falsifying reports! By having @stevonov send in the same samples that were sent to W&M, this was an opportunity to prove W&M was fake.

Upon reviewing the samples Jano couldn’t conclude that W&M faked anything, but maybe missed the Test E that wasn’t supposed to be there? No biggie...

So now what? Now is the time to put Pristine in the spotlight because the combined testing from the two different testing labs were too close for them to be faked?
With the reports on hand it looked to be that Pristine had lied about it being only one batch that was made that had cross contamination of another compound. It was more likely that it was from more than just a single batch with what the testing showed.
Jano was lookin to debunk W&M. By trying to do so Pristines inconsistency was outted instead...??
Am I way off here?

Anyway...
Here’s all the tests that I gathered (I think that’s all of em) with what’s being questioned...

087394AE-D04C-47DB-B4E5-D9A75DBCA6F4.png 59F8B155-2C8B-4852-B3BD-845B1343357E.png 0D2232BA-904C-4773-95E8-897F222B9708.jpeg 2CDF47FD-7C21-40D8-B6BA-9804D0C32CCF.png 4AEC51AA-0B28-443C-8899-468B3DE648D6.jpeg
 
Wish I would've read more of the thread before I placed an order. Lol. Probably would've went elsewhere.

Regardless, I placed an order last week. Communication was decent, packs were sealed properly and shipped in a timely manner. So far I can't complain. Obviously haven't tested them yet, so that could definitely change my opinion.
 
Wish I would've read more of the thread before I placed an order. Lol. Probably would've went elsewhere.

Regardless, I placed an order last week. Communication was decent, packs were sealed properly and shipped in a timely manner. So far I can't complain. Obviously haven't tested them yet, so that could definitely change my opinion.
What did you order?
 
I'm not avoiding the thread, it's just hard for me to post during the day, unless it's just a few sentences or a small update.

So this is why I want to prioritize testing finished product before raws. This shit is a nightmare.

First I will say that I've never intentionally added test or anything else that is not supposed to be in the vial. That just doesn't make any sense. Especially when I know that every vial I send out could potentially be sent in for testing. I don't believe it's a raws issue either. I think it's a polycap issue. When I switched from bottle-tops to polycaps, I was alternating two polycaps at a time. Purging between compounds with 100-200ml of oil to make sure none of the last compound remains when I filter the next compound. From what I've read, I thought this would be sufficient in getting rid of any lingering active from the previous compound. Obviously I was wrong about that.

When the bold cyp incident went down I went to cycling 6 polycaps, this was in early March.
Now I alternate 6 polycaps as so...

Test P/TNE/Sust
Test E/Test C
Tren A/Tren E
Mast P/Mast E/Sdrol
Deca/NPP
EQ/Bold Cyp/DHB

Now I purge 300ml of oil between compounds. Hopefully I've gotten as close as possible to eliminating any cross-contamination. The reason I wanted to test finished product is so I can see if something snuck in there prior to putting the batch on the market.

I want to sell product that matches what's on the vial. This shit is a complete embarrassment to me and I obviously I want the fuck-ups to cease and desist as much as everyone else who buys from me. I don't know what else to say other than I'm doing everything I can to make sure this isn't happening any more.
 
I'm not avoiding the thread, it's just hard for me to post during the day, unless it's just a few sentences or a small update.

So this is why I want to prioritize testing finished product before raws. This shit is a nightmare.

First I will say that I've never intentionally added test or anything else that is not supposed to be in the vial. That just doesn't make any sense. Especially when I know that every vial I send out could potentially be sent in for testing. I don't believe it's a raws issue either. I think it's a polycap issue. When I switched from bottle-tops to polycaps, I was alternating two polycaps at a time. Purging between compounds with 100-200ml of oil to make sure none of the last compound remains when I filter the next compound. From what I've read, I thought this would be sufficient in getting rid of any lingering active from the previous compound. Obviously I was wrong about that.

When the bold cyp incident went down I went to cycling 6 polycaps, this was in early March.
Now I alternate 6 polycaps as so...

Test P/TNE/Sust
Test E/Test C
Tren A/Tren E
Mast P/Mast E/Sdrol
Deca/NPP
EQ/Bold Cyp/DHB

Now I purge 300ml of oil between compounds. Hopefully I've gotten as close as possible to eliminating any cross-contamination. The reason I wanted to test finished product is so I can see if something snuck in there prior to putting the batch on the market.

I want to sell product that matches what's on the vial. This shit is a complete embarrassment to me and I obviously I want the fuck-ups to cease and desist as much as everyone else who buys from me. I don't know what else to say other than I'm doing everything I can to make sure this isn't happening any more.
When you switched over to red tops did you brew all new gear or swap tops on the old stuff.
 
That's the $64,000 question.

PPL had his domestic supplier busted.
He's still slinging raws like it never happened

Titter had overdosed gear and a single incident of a floater.
No one said a single negative word.

ARL had two underdosed tests and a piss poor attitude.
Torches are lit and ready to burn.

Venom was wanted out before test results even came back.
Torces were lit from day 1.

Pharmasourse can't dose properly to save his life.
No one seemed to give much of a shit.

Hilma fucked up with low fill levels and (anecdotally) bunk Clen. They're cool to stay.

Anabolic Store pissed off a customer regarding a refund.
Torches are lit and ready to burn.

There is no standard. The bar for acceptable fuckups changes with each source and how well they're liked by the loudest mouths of Meso.
This is the best post I’ve seen on Meso to date! You’re spot on here!
I missed the Hilma and Anabolic store while it was happening but still read it but everything was over by then.

I’ve tried to be consistent in every thread I’m in. Honestly the Pharmasource thread was the most shocking/disappointing to me! It was dismissed immediately and my comments were ignored!

If you have any ideas how to help set a standard I’m all ears. If not I’ll just keep doing what I’ve been doing.
I thought if I was consistent throughout the underground it would help with a standard but obviously my mouth isn’t loud enough... but imma still try! :D
 
This is the best post I’ve seen on Meso to date! You’re spot on here!
I missed the Hilma and Anabolic store while it was happening but still read it but everything was over by then.

I’ve tried to be consistent in every thread I’m in. Honestly the Pharmasource thread was the most shocking/disappointing to me! It was dismissed immediately and my comments were ignored!

If you have any ideas how to help set a standard I’m all ears. If not I’ll just keep doing what I’ve been doing.
I thought if I was consistent throughout the underground it would help with a standard but obviously my mouth isn’t loud enough... but imma still try! :D
Dont count yourself short bud, your mouth is plenty loud.[emoji57]
 
if he purposely put 20 percent test in the tren ace why not do short esters like in the masteron?
The masteron has sustanon in it bro, only short Ester would be super small amount of prop. This doesn’t correlate with the rotation @Trenity stated. Trenbolone and sustanon?? Come on?? Sure hope this is not some scam to get more gear before your contest you stated you have coming up.
 
Back
Top